axial motion

英 [ˈæksiəl ˈməʊʃn]

美 [ˈæksiəl ˈmoʊʃn]

网络  轴向运动

英英释义

noun

• rotary motion of an object around its own axis
  1. wheels in axial rotation
  Synonym:axial rotationroll

双语例句

• As for F2, it partially disappeared and then the rest showed horizontal axial motion, and eventually erupted wholly. ( 2) The eruptive mechanisms of the two filaments are different.
  而暗条F2一部分先消失，其余部分出现水平的轴向运动，最后F2整体爆发。
• The ranges of coupled axial rotational motion of flexion, extension, left lateral bending, and right lateral bending were, 12.42,16.14, 22.07 and 22.48 degrees respectively.
  寰枢关节屈曲，后伸，左右侧屈主运动时伴有明显耦合旋转运动，其范围分别是12.42°，16.14°，22.07°，22.48°。
• According to the definition of the angular momentum, the paper discusses any axial angular momentum of plane motion of rigid body, and works out the theorem of rotation of axis of center-of-mass and instant center in plane motion of rigid body.
  从角动量的定义出发，计论了刚体平面运动时对任一定轴的角动量，推出了刚体平面运动时对质心轴、瞬心轴的转动定理。
• The axial electromagnetic force acting on stator tooth obtained by calculation of motion electromagnetic field is applied to 3-D model of axial flux permanent magnet motor.
  由运动电磁场计算获得作用在定子齿表面上的轴向电磁力，并将电磁力加载到三维电动机结构模型上。
• The bearing pin is provided with a retaining bolt at end for preventing axial motion.
  为防止承重销轴轴向移动，在其端部安装止挡螺栓。
• The circular arc gear drive is one kind of axial conjugate gear drive which meshes in points. The movement transmission depends contact mark along the end motion to realize.
  圆弧齿轮传动是一种轴向共轭、点啮合制的齿轮传动，运动的传递依靠接触迹沿轴向移动实现。
• The theoretical basis of the existing research is basically established on Reynolds equation of two-dimensional movement without the axial motion when only consider circular motion of journal.
  上述现有研究的理论依据，基本上都是建立在只考虑轴颈的圆周运动、而不计轴颈轴向运动的二维运动Reynolds方程的基础之上。
• Axial motion and misalignment ( radial and angular offset) between the encoder shaft and the drive shaft are compensated by the coupling.
  轴向运动和编码器之间的偏差轴和传动轴（径向和角向偏移量）是由耦合补偿。
• MHD stability of a plasma column with axial motion
  轴向运动等离子体柱的磁流体力学稳定性
• The conclusions are drawed as follows: ( 1) The modification of the tooth surface must be done for decreasing the impact while oscillating teeth doing the axial reciprocating motion in the process of end face harmonic gear drive.
  在活齿端面谐波齿轮传动的过程中，为了减小啮合副中的活齿作往复直线运动时的惯性冲击，必须对各啮合副的理论齿面进行修形。